Advertisement
D40-1132-05
Reassembling
(a) Insert CM1 MAIN MOTOR into a hole in
while taking care not to damage the surface.
(b) In such a case, the direction of terminals should be as
shown in figure.
(c) Tighten two pieces of
(d) Insert lead wires from under the terminals, and solder
them.
(e) Engage the MAIN BELT in the order given in the figure.
12
(For
only pass the belt under them.)
(f) After engagement, check if the Belt is twisted. If it is twist-
ed, straighten the Belt with plastic tweezers, etc. Do not
use a metallic tool, which could damage the belt.
In engaging the Main Belt, do not bring the Main Belt in
contact with the edge of metallic parts to prevent a nick
or scratch.
1.9. &OP PLATE/(S.B PLATE
Disassembling
&
(a) Move
OP PLATE to the front end position.
K
(b) Remove
PK COLOR SCREW.
(
(c) Dismount
S.B PLATE.
Reassembling
(a) Insert bent portion A of S.B PLATE into a rectangular
4
hole A' in
MAIN PLATE.
(b) Insert portion B with a pin into a slot B' of OP PLATE
Ass'y.
(c) Insert portion C into a hole C' in
K
(d) Tighten
PK COLOR SCREW.
&
(e) Moving the
OP PLATE Ass'y to the front and rear,
check for smooth movement.
8
DISASSEMBLY FOR REPAIR
1
CHASSIS
E
42 X 3TAMS SCREWS.
1
CHASSIS.
Advertisement
