Advertisement
1.13. _EJECT LEVER
Disassembling
_
(a) Slide
EJECT LEVER until it gets stuck at the rear.
(b) Move it to the left, and it will be removed.
Reassembling
(a) Mount the Eject Lever Ass'y so that its portion A comes
1
under the
CHASSIS Ass'y as shown in figure.
(b) Push the Ass'y so that C, D, E, F portions enter C', D', E',
F' portions respectively.
(c) When all portions enter properly, the EJECT LEVER will contact the side surface of CHASSIS then slide it to the front as it is.
(d) Check if the EJECT LEVER falls by gravity. (If it cannot slide or does not fall by gravity, it will be stuck or de formed Check the
EJECT LEVER.)
1.14. @HEAD PANEL Ass'y
Disassembling
@
(a) Pull
HEAD PANEL Ass'y in arrow direction to disen-
gage hooks at three positions of CHASSIS, then raise it
upward.
Reassembling
4
(a) Adjust
MAIN PLATE so that its hole positions in the
center of Chassis as shown in figure.
(b) Mount the Head Panel Ass'y on the CHASSIS Ass'y
while taking care of four points shown in figure. (Leave
parts under the Ass'y positioned in the center, where
they may be in unstable state.)
(c) Slide the Ass'y in arrow direction. (If it does not slide
smoothly, unstable parts mentioned in step (b) may be
shifted to either side. In such a case, raise the Ass'y and
correct parts with tweezers, etc.)
DISASSEMBLY FOR REPAIR
D40-1132-05
11
Advertisement
