Advertisement
1.7. CM2 SUB MOTOR Ass'y
Disassembling
(a) Break the solders of two wires (violet and gray) of M
CONNECTOR WIRE.
(b) Remove two screws. (Assume that the GEARS were
already removed.)
Reassembling
(a) Insert CM2 SUB MOTOR while taking care not to allow
A GEAR to interfere with the edge of
(b) In such a case, meet screw holes with holes in the
CHASSIS as shown in figure.
E
(c) Tighten
42 X 3 TAMS SCREW.
(d) Solder lead wires of M CONNECTOR Ass'y.
1.8. —MAIN BELT/ CM1 MAIN MOTOR
Disassembling
—
(a) Disengage
MAIN BELT while :taking care not to dam-
age the back of Belt.
(b) Break the solders of two wires (red and brown) of M
CONNECTOR WIRE connected to CM1 MAIN MOTOR.
(c) Remove two screws. (Assume that the GEARS were
already removed.)
DISASSEMBLY FOR REPAIR
1
CHASSIS Ass'y.
D40-1132-05
7
Advertisement
