Burner Control Box Suspension - Brant Radiant Heaters DX3L Series Manual

DX3L Series

Burner Control Box Suspension

Suspending the burner control box must be done in accordance with applicable codes listed in the Safety
section and these instructions.
The burner control box must be in straight alignment with all radiant tubes and level. Contact your local
distributor or the factory to see if your application allows for the rotation of the burner control box.
Determine the mounting chain locations for hanging the burner control box.
1
Fasten beam clamp, screw hook or other type of suspension anchor to hanging point.
2
Attach S-hook and chain assembly (P/N: THCS) to anchor. Check that it is securely connected.
3
Attach chain assemblies and S-hooks to mounting brackets on the burner control box. Adjust chain lengths
4
until level and in straight alignment with radiant tubes. Burner sight glass will be visible from the floor.
Figure 3.14 • Burner Control Box Assembly
1
9.35"
Figure 3.15 • Burner Control Box with U-Bend
NOTE: Control Box Cover should allow for
clearance for easy service and maintance.
* Recommended U-Tube to the right.
• Side View
2
3
Burner Control Box tube is in
straight alignment with 10'
Primary Combustion Chamber
4
Burner Sight Glass
16"
12.875"
• End View
23
3.0 Installation • Burner Control Box Suspension
32.5"
16"
11.25"
18.5"
8.63"
4.5"
4"