Installation Instructions - Summit Appliance AccuCold FCL44 MED Series Use & Care Manual

INSTALLATION INSTRUCTIONS

Use two or more people to move and install your appliance.
Failure to do so can result in back or other injury.
CAUTION: YOU MUST ALLOW APPLIANCE TO SIT UPRIGHT FOR 24 HOURS
BEFORE TURNING ON, TO ALLOW THE COMPRESSOR LUBRICANT TO
DRAIN. FAILURE TO DO SO MAY ADVERSELY AFFECT PERFORMANCE
AND THE LIFETIME OF THE UNIT.
1. Remove packaging materials.
2. Remove tape and glue residue from surfaces before turning on the
appliance. Rub a small amount of liquid dish soap over the adhesive
with your fingers. Rinse with warm water and dry.
3. Do not use sharp instruments, rubbing alcohol, flammable fluids, or
abrasive cleaners to remove tape or glue. These products can
damage the surface of your appliance.
4. When Moving Your Appliance:
Your appliance is heavy. When moving the appliance for cleaning or
service, be sure to protect the floor. Always pull the appliance straight
out when moving it. Do not wiggle or "walk" the appliance when trying
to move it, because floor damage can occur.
5. Clean Before Using:
After you remove all of the packaging materials, clean the inside of
your appliance before using it. See cleaning instructions in Appliance
Care.
6. Some upright models have leveling legs. Level as necessary for best
operation.
7. If your appliance has casters, after moving into place, lock the brakes
on those casters supplied with brakes. Always unlock before moving
the appliance for cleaning.
Key Eject Lock (some models)
To lock or unlock the appliance, you must hold the key in the lock while
turning. The lock is spring loaded, so the key cannot be left in the lock.
If the key is lost, contact your dealer or SUMMIT APPLIANCE for a
replacement. Always give the model and serial number of your appliance
when requesting a replacement key. Keys for most models can be
ordered online at
Excessive Weight Hazard !
www.summitappliance.com/support
Felix Storch, Inc.
Page 3