Table of Contents
Advertisement
Quick Links
FROST-FREE DRAWER REFRIGERATORS
Model Nos. FF1DSS / FF12DROS / HDR13SS
BEFORE USE, PLEASE READ AND FOLLOW ALL SAFETY RULES AND OPERATING INSTRUCTIONS.
Write Serial Number (on lower left corner of
inside cabinet) here:
_______________________
Serial No.:
User Manual
Felix Storch, Inc.
An ISO 9001:2015 registered company
770 Garrison Avenue
Bronx, NY 10474
www.summitappliance.com
Advertisement
Table of Contents
Related Manuals for Summit Appliance FF1DSS
Summary of Contents for Summit Appliance FF1DSS
- Page 1 FROST-FREE DRAWER REFRIGERATORS Model Nos. FF1DSS / FF12DROS / HDR13SS User Manual BEFORE USE, PLEASE READ AND FOLLOW ALL SAFETY RULES AND OPERATING INSTRUCTIONS. Write Serial Number (on lower left corner of Felix Storch, Inc. inside cabinet) here: An ISO 9001:2015 registered company...
-
Page 2: Table Of Contents
TABLE OF CONTENTS Appliance Safety Important Safeguards Location of Parts Installation Instructions Before Using your Appliance Installation of your Appliance Electrical Connection Extension Cord Installing the Stainless Steel Handles Full Overlay Panel Installation Instructions Operating your Appliance 9-11 Control Panel 9-10 Interior Light Sabbath Mode... -
Page 3: Appliance Safety
APPLIANCE SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the Safety Alert Symbol. The symbol alerts you to potential hazards that can kill or injure you and others. - Page 4 • In the event of any damage: – Avoid open flames and anything that creates a spark, – Disconnect from the power source, – Air the room in which the appliance is located for several minutes, and – Contact the Service Department for advice. •...
-
Page 5: Location Of Parts
LOCATION OF PARTS... -
Page 6: Installation Instructions
INSTALLATION INSTRUCTIONS Before Using your Appliance • Remove the exterior and interior packing. • Before connecting the appliance to the power source, let it stand upright for approximately 2 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation. -
Page 7: Extension Cord
This appliance requires a standard 115/120 Volt AC ~ 60Hz three-prong grounded electrical outlet. Have the wall outlet and circuit checked by a qualified electrician to make sure the outlet is properly grounded. When a standard 2-prong wall outlet is encountered, it is your responsibility and obligation to have it replaced with a properly grounded 3-prong wall outlet. -
Page 8: Full Overlay Panel Installation Instructions
Full Overlay Panel Installation Instructions These models are designed for field-installed overlay panels. The overlay panels cover the stainless steel to give a built-in appearance. The overlay panel and appropriate hardware are not included with the unit and the end user needs to prepare them himself. Please follow the instructions below for installation: •... -
Page 9: Operating Your Appliance
OPERATING YOUR APPLIANCE It is recommended you install the appliance in a place where the ambient temperature is between 44º and 100ºF (7º to 38ºC). If the ambient temperature is above or below the recommended temperatures, the performance of the unit may be affected. For example, placing your unit in extremely cold or hot conditions may cause interior temperatures to fluctuate. -
Page 10: Interior Light
Setting the Temperature Control • You can set the temperature by touching the UP and DOWN symbols. When you touch either of the two buttons for the first time, the LED readout will show the original temperature set previously. (The temperature preset at the factory is 39°F or 4°C.) •... -
Page 11: Defrosting
Defrosting • Under normal operating conditions, the unit requires no manual defrosting. • The evaporator behind the rear wall of the unit defrosts automatically. The condensate collects in drainage channel behind the rear wall of the unit and flows through the drainage hole into the drip tray by the compressor where it evaporates. -
Page 12: Care And Maintenance
CARE AND MAINTENANCE Cleaning your Appliance • Turn off the power, unplug the appliance, and remove all items, including racks and dividers. • Wash the inside surfaces with a solution of warm water and baking soda (about 2 tablespoons of baking soda to a quart of water). -
Page 13: Troubleshooting
TROUBLESHOOTING You can solve many common problems easily, saving you the cost of a possible service call. Try the suggestions below to see if you can solve the problem before calling the servicer. Troubleshooting Guide PROBLEM POSSIBLE CAUSE REMEDY • Appliance is not connected to a power •... - Page 14 • The gaskets are dirty. • Clean the drawer gaskets. properly. • The racks or bins are out of position. • Check the racks and bins and refit correctly. • “E0” indicates a communication error • Call for service. for 3 zone models. •...
- Page 15 NOTES...
-
Page 16: Limited Warranty
LIMITED WARRANTY ONE-YEAR LIMITED WARRANTY Within the 48 contiguous United States, for one year from the date of purchase, when this appliance is operated and maintained according to instructions attached to or furnished with the product, warrantor will pay for factory-specified parts and repair labor to correct defects in materials or workmanship. Service must be provided by a designated service company.