Select Options - Atag VA9711QT Operating Instructions Manual

Table of Contents

Advertisement

Dishwashing
6

Select options

To select an option, press one of the option
buttons. The field under the button lights when the
option is activated. The available options depend on the
selected programme. Once you have started the
programme, the options you selected are saved for the
next time you use the same programme. An exception is
the Delayed start option.
High temperature
Activate this option for improved dishwashing results. The
machine then uses a higher temperature for the main
wash.
If you want to use the lower temperature, press again so
that the field under the button turns off.
You can vary the temperature as shown below:
Heavy wash:
55 °C/ 70 °C
Normal wash:
60 °C/ 65 °C
Daily wash:
60 °C/ 65 °C
Quick wash:
30 °C/ 60 °C
Super quick wash:
30 °C/ 60 °C
Delicate wash:
40 °C/ 50 °C
Eco wash:
55 °C/ 60 °C
Long dry
A higher temperature in the final rinse and a longer drying
phase improves the drying result if you activate the Long
dry option. This causes a slight increase in energy
consumption. This option can be used with all
programmes except Auto wash, Rinse & Dry and Rinse
& Hold.
If you want a programme with Short dry, press again so
that the field under the button turns off.
Delayed start
When you select Delayed start, the dishwasher will start
1-24 hours after you press the Start/Stop button.
1. Press the button once to activate Delayed start. Press
the button several times – or hold it in – to set the
desired number of hours.
2. Press Start/Stop and the dishwasher counts down 1
hour at a time and starts after the selected delay.
Press and hold Start/Stop for three seconds if you want
to cancel the Delayed start option.
NOTE!
Remember to press the Start/Stop button to start the
programme.
7
Press Start/Stop and close the
door
The display flashes three times with the remaining
time to indicate that the programme has started. Close
the door properly, otherwise the dishwasher will not start.
The display indicates
NOTE!
If the machine does not start within 2 minutes of the last
button press, the display returns to showing the last
programme run.
Stopping or changing a programme
If you want to change programme after starting the
dishwasher, open the door then press and hold Start/Stop
for three seconds. Add more detergent if the lid of the
detergent dispenser has opened. Then choose a new
programme, press Start/Stop and close the door.
Do you want to add more dishes?
Open the door. The dishwasher stops automatically. Add
the dishes, close the door and the dishwasher continues
the programme.
If the dishwasher is turned off using the
main power switch or due to a power
failure
If the dishwashing programme was not finished, the
interrupted programme continues when power is restored.
NOTE!
During drying, the programme is interrupted if the power
is cut or the door is open for more than 2 minutes.
if the door is open.
17

Advertisement

Table of Contents
loading

This manual is also suitable for:

Va9711qtuu/a01

Table of Contents