Table of Contents
Advertisement
Chapter 12
•
WMM:
This feature guarantees the packets with high-priority messages being
transmitted preferentially. WMM is enabled compulsively under 802.11n or 802.11ac
mode. It is strongly recommended to enable WMM.
•
Short GI:
This feature is enabled by default and recommended to increase the data
capacity by reducing the Guard Interval (GI) time.
•
AP Isolation:
Select this check box to enable the AP Isolation feature that allows you
to confine and restrict all wireless devices on your network from interacting with each
other, but still able to access the Internet. AP isolation is disabled by default.
•
WDS Bridging:
Select this check box to enable the WDS (Wireless Distribution System)
Bridging feature to allow the router to bridge with another access point (AP) in a
wireless local area network (WLAN). Refer to
instructions.
12 4
Set Up a Dynamic DNS Service Account
Most ISPs (Internet service providers) assign a dynamic IP address to the router and
you can use this IP address to access your router remotely. However, the IP address can
change any time and you don't know when it changes. In this case, you might need
the DDNS (Dynamic Domain Name Server) feature on the router to allow you and your
friends to access your router and local servers (FTP, HTTP, etc.) using domain name, in
no need of checking and remembering the IP address.
Note: DDNS does not work if the ISP assigns a private WAN IP address (such as 192.168.1.x) to the modem router.
To set up DDNS, please follow the instructions below:
1
Visit http://tplinkmodem.net, and log in with the password you set for the modem
router.
2
Go to
Advanced
3
Select the
DDNS service provider
account, select a service provider and click
> Network>
Dynamic DNS.
(Dyndns or NO-IP). If you don't have a DDNS
Specify Your Network Settings
Appendix: Troubleshooting
Go to
register.
for detailed
76
Advertisement
Table of Contents
