Installation Instructions; Construction; Location; Electrical Connections - Hoshizaki FM-150KE-50 Instruction Manual

I. INSTALLATION INSTRUCTIONS

1. CONSTRUCTION

Operation Panel
Front Panel (Left)

2. LOCATION

This icemaker is not intended for outdoor use.
The icemaker should not be located next to ovens, grills or other high heat producing equipment.
This appliance is not suitable for installation in an area where a water jet could be used.
The location should provide a firm and level foundation for the icemaker.
Do not place anything on top of the icemaker or in front of the louver.
Normal operating ambient temperature should be within 5°C to 40°C. Water connection is cold water only. Operation of the
icemaker, for extended periods, outside of these normal temperature ranges may affect production capacity.
Allow the clearance specified below for proper air circulation and ease of maintenance and/or service should they be required.
Top View
Left
15cm
In some high humidity environments, condensation may form inside the machine and drip onto the floor. Do not install where
the floor can be affected by water.

3. ELECTRICAL CONNECTIONS

This icemaker requires an earth that meets the national and local electrical code requirements.
Disconnect the main power supply before any maintenance, repairs or cleaning is undertaken.
* Usually an electrical permit and services of a licensed electrician are required.
Louver
Air Filter
WARNING
NOTICE
IMPORTANT
Rear
15cm
Right
15cm
ICEMAKER
Front
WARNING
THIS APPLIANCE MUST BE EARTHED
Top Panel
CAUTION
Side View
Front
3
ENGLISH
Storage Bin
Door
Front Cover
Top
15cm
Rear
15cm
ICEMAKER