Sagitter SG AQUPAR18 User Manual page 21

Upload (*)
CAL WHITE
Setup
Info
Reset
(*) Notes:
UPLOAD mode is used do transfer the CUSTOM programs from one projector to the others.
- Connect in chain all the projectors
- Set all the units in SLAVE mode, except the first unit, where there are the CUSTOM
programs
- On the first unit press UPLOAD, all the custom programs will be sent to the other units.
5.2 – MASTER/SLAVE MODE
In this mode, more units can be linked together as a single chain and work in a synchronized
way.
• Link together all the units from the connector DMX OUT to DMX IN.
• Define the first unit of the chain as MASTER, all other units must be set in SLAVE mode.
• Operate the Master unit in Automatic mode or Static mode to operate the entire system.
The entire chain of Slave unit will act as the Master unit
ID number:
OFF - 01 ... 66
Red: 000 - 255
Green: 000 - 255
WHITE 1 ...
WHITE 11
Blue: 000 - 255
White: 000 - 255
Key Lock:
OFF - 5S
LCD Black:
ON - 30S
MAX TEMP:
30° - 65°
DIMMER ALL:
000 - 255
Factory Reset
Working time:
00000h-00m
Software Ver:
V.x.xx
Hardware Ver:
V.x.xx
21
Password:
UP - DOWN - UP - DOWN - ENTER
Impostazione ID
White balance
Manual red adjustment
White balance
Manual green adjustment
White balance
Manual blue adjustment
White balance
Manual white adjustment
Set display lock
Unlock password:
UP - DOWN - UP - DOWN - ENTER
Display settings:
ON = always ON
30S = OFF after 30 seconds
Settings the limit temperature.
Over this temperature, the light of
the LEDs is reduced.
Max dimmer limit setting
Factory reset
Working time
Software version
Hardware Version
Reset - Password:
UP - DOWN - UP - DOWN - ENTER