Cannot Print Properly Through Wireless Communication; Cause; Action - Canon PIXMA mini260 Photo Printing Manual

Camera Error Message
Hardware Error
Printer error
*1
To resume printing, you can press the OK button on the printer instead of selecting Continue.
Cannot Print Properly through Wireless
Communication

Cause

Printer placement is
inadequate.
During infrared communication,
infrared rays were blocked.
The conditions to print properly
through the infrared
communication are not met.
The mobile phone or the PDA is
too far away from the printer
(For Bluetooth communication).
The optional battery has running short. Follow the procedure
below.
(1) Turn the Printer off.
(2) Connect the supplied AC adapter or attach the charged
battery.
(3) Turn the Printer on.
The ink tank error has occurred.
Replace the ink tank. See "Replacing an Ink Tank" on page 47.
An error requiring servicing might have occurred (POWER lamp
and Alarm lamps flash alternately).
Disconnect the cable between the printer and the camera, turn
off the printer, and unplug the power cord of the printer from the
power supply. After a while, plug the power cord of the printer
back in, turn on the printer, and then reconnect the camera to the
printer.
If the same error occurs, contact a Canon service representative.
When printing through infrared communication, confirm that the
IrDA ports on the printer and the mobile phone are placed face to
face with each other at a proper angle and distance, and that
there is nothing blocking them. Then, retry printing.
Operational distance and angle vary depending on the
specifications of your mobile phone and your operating
environment, but generally place the printer within around 8
inches / 20 cm from the mobile phone in a position that enables
proper communication.
During sending, be careful not to interrupt infrared
communication with the printer. If it is interrupted, send the data
from the mobile phone or the PDA again.
The infrared communication function of the printer is only
compatible with mobile phones with IrDA compliant infrared
communication ports. Printing through infrared communication
cannot be performed by any other types of mobile phones.
See "Printing Photographs from a Wireless Communication
Device" on page 36.
Place the mobile phone or the PDA within 33 feet (10 m) of the
printer when attempting to print via a wireless communication.
Try This

Action

Troubleshooting 71