Printing Photographs Directly From A Pictbridge Compliant Device - Canon PIXMA mini260 Photo Printing Manual

3
Connect the PictBridge compliant device to the printer.
Note
Depending on your device, you may have to select a mode of printing photos compliant with
PictBridge before connecting the device.
You may also have to turn on the device or select Play mode manually after connecting the device
to the printer.
Perform necessary operations according to the instruction manual supplied with your PictBridge
compliant device.
(1) Make sure that the PictBridge compliant
device is turned off.
(2) Connect the PictBridge compliant device to
the printer using a USB cable
recommended by the manufacturer of the
device.
The device turns on automatically.
If your device does not turn on
automatically, turn it on manually.
(3) Set up the PictBridge compliant device for
direct printing.
will appear on the LCD of the device
when the printer is correctly connected.
Note
If does not appear, see "Cannot Print Properly from the Digital Camera" on page 69.

Printing Photographs Directly from a PictBridge Compliant Device

When operating the device, be sure to follow the instructions given in the instruction manual of
your PictBridge compliant device. This section describes the page size, media type, layout,
image optimization modes, and date printing mode that can be set on a PictBridge compliant
device connected to the printer.
Confirming or Changing the Device Settings
To change the paper size or paper type, operate the device to select the PictBridge print
setup mode and confirm or change the settings.
About the Settings Explained Below
Some setting items explained below may not be available on some devices. In this case, the
Default setting explained below is applied for the setting item.
* In the following description, names of settings items are given according to those used in
Canon-brand PictBridge compliant devices. Setting item names may be different
depending on the brand or model of your device.
When a PictBridge compliant device is connected, the settings below can be changed by
pressing Device settings in the Settings of the printer, then select PictBridge settings.
However, changes can be made only when the corresponding item is set to Default (the
setting to follow that of the printer) on the PictBridge compliant device.
32 Printing Photographs Directly from a Digital Camera