CNET CWR-901 User Manual page 19

- Select WAN Connection Type: Select the Unnumbered PPPoE connection
- Login ID: Enter the login ID provided by ISP
- Password: Enter the Password provided by ISP
Service Name: The Service Name set on the access concentrator. Many ISPs give
-
user-name and address in the form of user-name@service-name. The Service
Name provided by ISP, if one is required, otherwise, leave it blank.
- AC Name: Access concentrator name provided by ISP, if one is required, otherwise,
leave it blank.
- MTU: MTU is the Maximum Transmission Unit. It specifies the largest packet size
permitted for Internet transmission. Keep the default setting, 1492, to have the
wireless router select the best MTU for your Internet connection. Sometimes ISP
sets different MTU size than 1492.
- IP Address: The unnumbered IP subnet address, assigned by ISP.
Network Mask: Network size of the unnumbered IP subnet. If network mask is
-
255.255.255.248, then this wireless router supports five unnumbered IP hosts in
LAN and uses one IP in allocated IP subnet for gateway itself.
- NAPT for LAN hosts: If checked, the wireless router enables NAPT function for
LAN PCs using configured LAN IP address (ex: 192.168.1.x). If unchecked, NAPT
is disabled and the wireless router will route packets to and from LAN PCs using
unnumbered IP addresses.
- Dial-On-Demand: If checked, the wireless router will only dial this session when
a LAN -> WAN packet is received. If unchecked, the wireless router immediately
dials the session when powered up.
- Silent timeout: Only used when connection type is set to Dial-On-Demand. The
Silent timeout value is defined as the time for the WAN port to disconnect if the
connection is idle. (not used).
- Auto Reconnect: If checked, the router redials the session if previously terminated
by ISP.
19