Important Precautions - Abilica TM10 Manual

Important Precautions

Part Recomended maintenance
Display Clean with a soft, clean and moist cloth.
Frame Clean with a soft, clean and moist cloth.
Running belt Clean with a soft, clean and moist cloth.
Clean with a soft, clean and moist cloth. Make sure that it has sufficient
Running deck applied lubricant and the surface is smooth.
Inspect that the drive belt is sufficiently tight, check for any wear and
Drive belt that drivebelt is in the correct position.
Bolts, nuts etc. Inspect all bolts, nuts and screws. Thighten if necessary.
* Always use the manufacturer's recommended lubricant
Warning: Read all instructions in the user manual before using the product.
Take good care of user manual, do not throw it away.
When using an electrical product, basic precautions must be taken to avoid fire, electric
shock or material and personal injury. The treadmill should only be used as described in this
manual. It is the owner`s responsibility of that all users of the product are aware of, and
follow with the precautions described in this manual.
Connection and grounding instructions
Warning: The product may only be connected to the properly grounded electrical
outlet
This product must be grounded. If a ground fault occurs, any hazard will then be reduced if
the product is connected to a grounded plug. Connection to grounded plug also reduces the
possibility of static charges that can cause static shock, electromagnetic noise, and damage
to electrical components.
The product is equipped with cable with grounding conductor and grounded plug. The plug
must be connected to a suitable electrical outlet that is installed and grounded accordingly to
local regulations. The plug must not be modified in any way, if the plug does not fit the
electrical outlet, suitable outlet must then be installed by a qualified electrician.
The product should be used on a nominal 220-240 volt course with grounded plug. We
advice that the product should be used on a dedicated course, it is recommended 16 Amps
course for treadmills. Avoid using extension cord.
Before useing the produckt
Placing your treadmill
The treadmill must stand on a flat and stable surface. It is recommended to have 2 meters
clearance behind the treadmill, 1 meter on each side and 30 centimeters in front to fit the
power cord and to put the treadmill in storage position.
Place your treadmill somewhere that does not block valves or vents. The treadmill should be
indoors in a climate-controlled room and in a dry environment. It must not be placed in a
40
How often? Cleaning Lubrication
After use No
After use Water
Weekly No
Weekly No
Monthly No
Monthly No
No
No
No
Yes*
No
No