Use Instructions - Pan Acoustics VESA VSM Assembly Manual

Assembly Manual

4.2. Use instructions

Prior to assembly, the VESA mounting points on the display on which the VSM / VSM XL loudspeaker
mount and the VESA monitor mount are to be mounted must be checked. The VSM / VSM XL loud-
speaker mount must lay fl at on the display. Mounting should preferably be done with the display
laying on its front. The front of the display must be protected from damage using suitable material.
The installation and commissioning of loudspeakers must only be carried out by qualifi ed personnel.
It has to be ensured that the mount chosen meets the required specifi cations and operational
requirements.
National safety regulations for operation and assembly must be followed.
CONNECTION OF THE LOUDSPEAKER AND MOUNT
• All mounts sourced via Pan Acoustics are delivered with suitable assembly material for connec-
tion to the loudspeaker.
• The connection between the loudspeaker and the mount is made by fi xing points (e.g. a slot nut,
which is inserted into the rear slot of the loudspeaker and tightened with two M6 set screws).
• To avoid damage to the mounts and the loudspeakers, no screws longer than the original ones
must be used. Longer screws may destroy the stability of the loudspeaker or cause short circuits
inside the loudspeaker.
• A tightening torque of 14 Nm must be observed for the screw connection between the mount
and the loudspeaker.
CAUTION
Incorrectly selected fastening material and incorrectly made screw connections can cause the loud-
speakers and display to fall or be damaged.
WARNING
Connection cables must not be used for fi xing or suspending loudspeakers.
© Pan Acoustics GmbH Page 8 of 14