Advertisement
Assembly Manual
2.1. Scope of delivery
Description
Slider 30 x 5 x 90mm
Threaded pin, M6 x 8mm socket bolt, A2, DIN 916
Mount (loudspeaker)
Allen screw M6 x 10mm, A2, DIN 7984
Wall mount
Axle element
Hexagon nut, M6, DIN 985
Hex bold, M6 x 35mm, DIN 933
Half bolt with allen, M8 x 16mm 10.9 vz, ISO 7380
Washer, M8
Cap
Product information for Pan Acoustics accessories
Screws and dowels for the attachment to the wall are not included in the scope of delivery. These
must be individually matched to the structure and material of the wall.
The mount is to be carefully inspected upon receipt for shipping damage and completeness. In case
of damage, the forwarder and sender are to be notifi ed without delay.
Safety may be impaired if the product:
•
shows signs of visible damage.
•
has not been delivered completely.
•
has been stored under adverse conditions for a prolonged period.
•
has been improperly shipped (e.g. unsuitable packaging).
If the product shows signs of impairments that no longer guarantee safe operation, the article is to
be secured and labeled accordingly. It should also be ensured that no intentional or inadvertent use
by third parties is possible.
3. Safety instructions
The following safety regulations are to be read completely and diligently prior to installing the mount
and afterwards kept in a safe place near the device. Reading the instruction manual is no substitute
for knowing and following all valid local safety regulations and rules. Persons assigned to the assembly
of equipment must be properly trained and are required to work with proper personal protection
equipment. Furthermore, the assigned persons are responsible for, and are to guarantee, the safe
setup and use of the speaker.
•
Power and signal lines must never be used for suspending, rigging or securing speakers.
•
Only use the mount intended for mounting specifi ed products in order to guarantee safe operation
of the products.
•
When attaching the mount to a wall, check the weight capacity, rigidity and type of wall. In case
of a porous base surface, for instance, additional measures are to be taken by the assembler to
prevent the screw connection from breaking out of the wall.
•
Only the original parts delivered by Pan Acoustics are allowed to be used for assembly.
The use of other parts, in particular parts from unknown or third-party manufacturers, is prohibited.
•
Please undertake to ensure that all mounting and fastening materials conform to the relevant
safety guidelines and are suffi ciently dimensioned.
•
Undertake to ensure that all connections are friction locking and form fi tting, and secured against
self-loosening.
© Pan Acoustics GmbH
V 1.0
Quantity
1
2
1
2
1
1
2
2
2
2
4
1
TWM III
Page 3 of 7
Advertisement
