Supported Vesa Hole Patterns; Assembly Steps - Pan Acoustics VESA VSM Assembly Manual

Assembly Manual

4.3. Supported VESA hole patterns

The following hole patterns are supported:
VSM:
Category: 55''
Category: 65''
VSM XL:
Category: 75''
Category: 86''
Category: 98''

4.4. Assembly steps

Step 1:
Position the four components (A) on the
back of the display as shown in the lower
picture. The holes in the components permit
exact (horizontal)
to the respective VESA hole pattern. The
components (A) must be flush with the sides
of the display.
Alternative assembly of component (A)
Component (A) can alternatively be mount-
ed as shown. This variant is preferred for the
VSM XL loudspeaker mount in order to better
adapt the loudspeakers to be mounted to the
depth of the display. In this case, the spacers
(I) under component (A) must be positioned
centred over the VESA mounting points.
© Pan Acoustics GmbH
positioning according
I
VESA H: 200/300/400
VESA V: 200/300/400
VESA H: 300/400/600
VESA V: 200/300/400
VESA H: 400/600/800
VESA V: 200/300/400/600
VESA H: 400/600/700/800
VESA V: 200/300/400/600
VESA H: 800
VESA V: 400/600
I
I
I
I
Page 9 of 14