Instructions For Operation - Max CN650M Operating And Maintenance Manual

4. INSTRUCTIONS FOR OPERATION

1.
q Wear Safety Glasses or Goggles.
w Do not connect the air supply.
e Inspect screw tightness.
r Check operation of the contact arm & trigger if moving smoothly.
t Connect the air supply.
y Check the air-leakage. (The Tool must not have the air-leakage.)
u Hold the Tool with finger-off the trigger, then push the contact arm against the work-piece. (The
tool must not operate.)
i Hold the Tool with contact arm free from work-piece and pull the trigger. (The Tool must not
operate.)
o Disconnect the air supply.
2.
WARNING:
Danger to the eyes always exists due to the possibility of dust being blown up by the exhausted air
or of a fastener flying up due to the improper handling of the tool. For these reasons, safety glasses
or goggles shall always be worn when operating the tool.
The employer and/or user must ensure that proper eye protection is worn. Eye protection equipment
must conform to the requirements of the American National Standards Institute, ANSI Z87.1 (Council
Directive 89/686/EEC of 21 DEC. 1989) and provide both frontal and side protection.
NOTE: Non-side shielded spectacles and face shields alone do not provide adequate protection.
Keep hands and body away from the discharge outlet when driving the fasteners because of
WARNING:
dangerous of hitting the hands or body by mistake.
Door latch
Magazine
Nail support
Read section titled "SAFETY INSTRUCTIONS".
BEFORE OPERATION
OPERATION
NAIL LOADING
q Open the magazine:
Hold door and door latch by fingers and pull up door latch. Swing door open. Swing
magazine cover open.
w When you want to use 27 mm nails, attach a nail support to the magazine.
9