Assembly Instructions - Guild BMS210G Instruction Manual

Assembly Instructions

NOTE: Before using the tool, read the instruction book carefully.
Intended Use
This tool is intended as a stationary machine for making straight lengthways and
crossways cuts in wood. Horizontal mitre angles of -45° to +45° as well as vertical bevel
angles of 0° to +45° are possible.
ASSEMBLY
WARNING: To prevent accidental starting that could cause possible serious
personal injury, ALWAYS assemble all parts to your saw BEFORE connecting it to
the power supply. The saw should NEVER be connected to a power supply when you are
assembling parts, making adjustments, installing or removing blades, or when not in
use.
1. DUST EXTRACTION PORT (SEE FIG A)
To reduce build up of saw dust and maintain cutting efficiency, the saw dust collection
can be achieved by clipping a dust bag on the dust extraction port (16).
A dust bag is provided for use on your mitre saw. To install it, simply fit the dust bag over
the extraction port on the upper blade guard.
To empty the dust bag, remove it from the dust exhaust port, open the dust bag by
unzipping the slide fastener.
NOTE: To ensure optimal dust collecting, empty the dust bag when it becomes filled to
approximately 2/3 of its capacity.
2. THE SUPPORT STAND (SEE FIG B1, B2)
Pull the support stand to its extreme, as shown in Fig B1, B2.
WARNING: Always keep the support stand at its extreme out position when using
the product.
A
B1
8
16
Customer Helpline 0333 3201989
B1
B2