Assembly Instructions - Guild BTS180B Instruction Manual

Assembly Instructions

NOTE: Before using the tool, read the instruction book carefully.
Intended Use
This tool is intended for cutting wood and similar material e.g. MDF and chipboard, plastic
This product should not be used on other materials or those harmful to health. It is to be
used for dry operation only without water or other cooling liquids.
This product is intended for private domestic use only, not for any commercial trade use. It
must not be used for any purposes other than those described.
USING THE SAW
Before putting the tool into operation
The tool has to be set up where it can stand firmly, e.g. on a work bench, or it must be
bolted to a strong stand.
All the covers and safety devices have to be properly fitted before the tool is switched on.
It must be possible for the TCT blade to run freely.
When working with wood that has been processed before, watch out for foreign bodies such
as nails or screws etc.
Before you actuate the On/Off switch, make sure that the TCT blade is correctly fitted and all
moving parts run smoothly.
Before you connect the tool to the power supply, make sure the data on the rating plate is
the same as that for your mains.
1� ON/OFF SWITCH
To switch on the saw, press the green button "I". Allow the blade to reach full speed before
cutting. To switch off, press the red button "O".
2� PARALLEL GUIDE
To mount the parallel guide, slide the parallel guide (10) onto the saw table (1), and fasten it
with the two parallel guide locking screws (a) provided. (SEE FIG A1, A2)
A1 A2
a
Customer Helpline 0333 3201989
8