Maintenance - Guild BMS210G Instruction Manual

H2

Maintenance

WARNING: Remove the plug from the socket before carrying out any adjustment,
servicing or maintenance.
When all the adjustments, settings or maintenance have been done, make sure that all keys and
wrenches have been removed and that all screws, bolts and other fittings are securely tightened.
There are no user serviceable parts in your power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean with a dry cloth. Always store your power tool
in a dry place. Keep the motor ventilation slots clean. Keep all working controls free of dust.
Occasionally you may see sparks through the ventilation slots. This is normal and will not
I2
damage your power tool.
If the supply cord of this power tool is damaged, it must be replaced by a specially prepared
cord available through the service
1. PRECISION SETTING OF ANGLES (SEE FIG J1, J2, K1, K2)
While the machine has been factory set, it is advisable that the 0
and the 90
in transit. (Ensure power is disconnected while making these adjustments).
To confirm the 0
locking knob. Check that the angle between the straight guide and the blade is 90
try square (b, not supplied) as shown in Fig. K1. If the angle requires adjustment, loosen the
locking screws for straight guide, and align the fence against the try square.
Re-tighten the locking screws for straight guide. (SEE FIG J1, J2)
J1
b
K1
b
12
L1
perpendicular setting of the tilt be checked, as these positions may have moved
o
rotary table setting, set the rotary table at 0
o
Customer Helpline 0333 3201989
b
I1
o
J2
K2
20
L2
19
setting of the rotary table
o
and tighten the rotary table
o
c
using a