Table of Contents
Advertisement
6
GENERAL MAINTENANCE
WARNING
Make sure the machine is turned off and the cord is
disconnected from the power source before servicing and
removing/replacing any components on the machine.
• Check the dust collector daily for loose mounting bolts,
screws, damaged wires, worn switch, full collection bag
6
and any other unsafe condition.
• The impeller screw may loosen with use. Check the
impeller once a month to ensure the impeller screws are
tight, securing the impeller on the shaft.
To check: Make sure the machine is turned off and the
cord is disconnected from the power source. Access the
impeller screws through the inlet cover on the machine
and tighten to secure the impeller on the shaft.
CLEANING
Check and empty the collection bag on your dust collector
regularly. The machine operates at a much higher level of
efficiency when the collection bag is empty.
This collection bag has a clear window and a bottom
zip. The clear window allows operator to see the amount
of dust in the bag and the bottom zip makes bag
emptying easy.
MAINTENANCE
LUBRICATION
The sealed bearings in the motor have been
permanently lubricated at the factory. They require no
further lubrication.
MACHINE STORAGE
• When the dust collector is not in use, disconnect the
cord from the power source and store the machine in a
dry place.
• Do not expose the machine to rain.
• Ensure the cord is kept away from potential damage
sources such as; sharp objects, chemicals, heat sources
and water.
TOOL REPAIRS
• If power cord is worn, cut, or damaged in any way, have
it replaced immediately.
• Replace worn abrasives when needed.
• Replace any damaged or missing parts. Use parts list
to order parts. Any attempt to repair motor may create
a hazard unless repair is done by a qualified service
technician. Call the customer service line at
847-780-6120 for assistance.
Advertisement
Table of Contents
