Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for PowerTec DC1081
Summary of Contents for PowerTec DC1081
- Page 1 Model No. DC1081 Owner's Manual 1 HP Dust Collector Visit us on the web at www.powertecproducts.com You will need this manual for safety instructions, operating procedures, and warranty. Put it and the original sales invoice in a safe, dry place for future reference.
-
Page 2: Table Of Contents
TABLE OF CONTENTS PRODUCT SPECIFICATIONS SECTION PAGE Motor . . . . . . . . . . . . . . . . . . . . . . . .1-HP, 120/240 V, 60-Hz, 1PH Motor Speed . -
Page 3: Safety Rules / Warnings
SAFETY RULES TOOL MAINTENANCE WARNING • Always unplug tool prior to inspection. For your own safety, read and understand all warnings and • Consult manual for specific maintenance and adjustment operating instructions before using any tool or equipment. procedures. WARNING • Keep tool lubricated and clean for a safe operation. Some dust created by power sanding, sawing, grinding, drilling •... -
Page 4: Contents
SPECIFIC SAFETY WARNINGS • Always wear approved eye protection and respirator when WARNING emptying collection/filter bags. Read and understand the instruction manual before operating • Ensure the machine is turned off before unplugging the Dust Collector. Basic precautions listed below should the Dust Collector. -
Page 5: Assembly
ASSEMBLY INSTALLATION 3. See Figure 4. Attach the two Rectangular Supports (D) to the Refer to Figures 2–4 Collector Body using the M8 Flange Bolts. Use the supplied 12 mm Wrench to tighten hardware. Tools required for assembly: 4. Attach Round Support (E) to Collector Body with Carriage •... - Page 6 7. See Figure 6. Carefully set the assembly upright onto the 10. See Figure 8. Thread one Quick Release Bag Clamp (J) casters. through the hemmed opening in the bottom of Filter Bag (G) 8. Assemble Handle (F) to the Collector Body with two Flange Figure 8 Bolts-M8.
-
Page 7: Test
GROUNDING INSTRUCTIONS 14. See Figure 11. Carefully fit Clear Plastic Collection Bag (H) over the lower opening of the Collector Body ensuring the WARNING top of the bag is positioned over the Adhesive Foam Strip. Improper connection of equipment grounding conductor can 15. -
Page 8: Motor
MOTOR TO CONVERT 1. Make sure the tool is unplugged. The Dust Collector is assembled with motor and wiring installed. The electrical wiring schematic is shown in Figure 13. 2. Open the switch box cover. 3. Follow the 240V wiring diagram on the inside of the switch Figure 13 box cover. - Page 9 OPERATION BASIC OPERATION Figure 17 ON/OFF Switch See Figure 17 The Keyed Switch is intended to prevent unauthorized use of the dust collector. 1. To turn the Dust Collector ON insert the Yellow Switch Key into the key slot in the center of the switch. 2.
- Page 10 FENCE ASSEMBLY MAINTENANCE GENERAL MAINTENANCE LUBRICATION The sealed bearings in the motor have been permanently WARNING lubricated at the factory. They require no further lubrication. Make sure the machine is turned off and the cord is MACHINE STORAGE disconnected from the power source before servicing and removing/replacing any components on the machine.
- Page 11 DUST COLLECTOR PARTS ILLUSTRATION...
- Page 12 When requesting warranty service, you must present the proof of purchase documentation, which includes a date of purchase. POWERTEC will either repair or replace any defective part, at our option at no charge to you. The repaired or replacement unit will be covered by the same limited warranty for the balance of one year warranty period.