Table of Contents
Advertisement
High-Wall Type
SMMS High-Wall Type
11.
Applicable Controls
A wired remote controller is necessary for this function. This function cannot be operate with a wireless
remote controller.
REQUIREMENT
• When this air conditioner is used for the first
time, it takes approx. 5 minutes until the remote
controller becomes available after power-on.
This is normal.
<When power is turned on for the first time
after installation>
It takes approx. 5 minutes until the remote
controller becomes available.
Power
"SETTING"
flashes
on
<When power is turned on for the second (or
later) time>
It takes approx. 1 minute until the remote
controller becomes available.
Power
"SETTING"
flashes
on
• Normal settings were made as factory default.
Change the indoor unit settings as required.
• Use the wired remote controller to change the
settings.
* The settings cannot be changed using the wireless
remote controller, sub remote controller, or
remote-controller less system (for central remote
controller only). Therefore, install the wired remote
controller to change the settings.
27-EN
Approx. 5 minutes
"SETTING"
Remote
goes out
controller is
available
Approx. 1 minutes
"SETTING"
Remote
goes out
controller is
available
Basic procedure for changing
settings
Change the settings while the air conditioner is not
working.
(Stop the air conditioner before making settings.)
The display content for setting differs from that on
the former types of remote controller (RBC-
AMT21E / AMT31E). (The number of CODE No.
has increased.)
4
6
1
1
Push
button and "TEMP."
simultaneously for at least 4 seconds.
After a while, the display flashes as shown in the
figure.
Confirm that the CODE No. is [01].
• If the CODE No. is not [01], push
erase the display content, and repeat the
procedure from the beginning.
(No operation of the remote controller is accepted
for a while after
(While air conditioners are operated under the
group control, "ALL" is displayed first. When
is pushed, the indoor unit number
displayed following "ALL" is the header unit.)
(* Display content varies with
the indoor unit model.)
– 27 –
Installation Manual
5
2
button
button to
button is pushed.)
1
3
Advertisement
Table of Contents
