Memory Fault S - Hitachi IJ RX2-SD160 Instruction Manual

No.
Charge Voltage
14
Too Low
Charge Voltage
15
Fault
No Ink Drop
16
Charge
Ink Heating Unit
17 Temperature
Sensor Fault
18 Memory Fault C
19 Memory Fault op
20 Memory Fault M
Ink Drop Charge
21
Error
Internal
22 Communication
Error S
System Operation
23
Error S
Ink Heating
24
Unit Over Current
Ambient
25 Temperature
Sensor Fault
Print Controller
26
Cooling Fan Fault

30 Memory Fault S

31 Pump Motor Fault Pump motor is faulty.
Inside Temperature
32
Sensor Fault
Ink Heating Unit
34
Temperature Low
9-4 ●On-screen message descriptions
Message
The charging voltage supplied to the nozzle
drive board EZJ125 from the high-voltage
power supply unit is too low.
The charge electrode signal is faulty.
The ink drops are not electrically charged.
The temperature measured at the ink
heating unit is out of normal range.
The heater will be temporarily deactivated.
The memory data has a fault.
The memory of the option board EZJ130
has a fault.
The memory data has a fault.
Charge control on ink drops has a fault.
No print or disordered print may occurs.
The internal data processing error.
Unexpected error occurred.
Please verify if the work is printed
correctly.
The ink heating element is shorted.
The heater will be temporarily deactivated.
The ambient temperature measurement is
out of normal range.
The cooling fan of the print controller area
is faulty.
The memory data has a fault.
The inside temperature measurement is out
of normal range.
The ink heater in the print head is unable to
heat the ink enough to reach the correct
operating temperature.
The heater will be temporarily deactivated.
Meaning of message Remedy
● Contact your nearest local
distributor.
● Check that there is no short-
circuit with another part.
● Check if the ink stream is at
about the center of the gutter.
● Clean the gutter, deflection
electrode, and its
surroundings.
● Adjust the excitation V-ref. to
make sure that the ink drops
are well made.
( Technical manual 6.11).
● Check the ink pressure.
( Technical manual 6.10).
● Contact your nearest local
distributor.
● Execute system setup.
● Contact your nearest local
distributor.
● Contact your nearest local
distributor.
● Contact your nearest local
distributor.
● Turn the power OFF and then
back ON after 10 seconds.
● Afer ink is stopped, turn OFF
the power of the printer.
● Contact your nearest local
distributor
● Contact your nearest local
distributor.
● Contact your nearest local
distributor.
● Contact your nearest local
distributor.
● Contact your nearest local
distributor.
● Contact your nearest local
distributor.
● Contact your nearest local
distributor.
● Contact your nearest local
distributor.