Table of Contents
Advertisement
Chapter 8 - Troubleshooting
Symptom
Unit does not respond to
front panel controls.
MIDI Program Changes
are off by 1.
Checking the Software Version
The current software version may be determined by holding [GLOBAL] and pressing
[PROGRAM]. The display will indicate the currently installed software version.
SOFTWARE VERSION:
Re-initializing
To re-initialize the Q20, hold down both [PROGRAM] and [COMPARE] while
turning on the power. This will reset all Global parameters to their default
settings, and will initialize the edit buffer so that the current Program is set to its
default settings (no Blocks/routings). However, none of the Programs in the User
bank or the Preset bank are changed when re-initializing the unit this way.
Total Reset
A more drastic version of re-initializing the Q20 will erase all User Programs, as
well as resetting all Global parameters. Hold down [PROGRAM], [COMPARE],
and [<BLOCK] simultaneously while turning on the power.
116
Cause
Unknown software
conflict, cosmic rays,
boogieman/men or static
electricity.
Transmitter doesn't
display true MIDI
Program Change numbers.
2.02
Solution
Disconnect MIDI input.
Power down and power
up. If this doesn't work,
try reinitialization, then
total reset (see later in
this chapter).
Change the transmitter to
display 0-127, or setup a
Program Table in the Q20.
Q20 Reference Manual
Advertisement
Table of Contents
