Routings; To Specific Adat Tracks - Alesis Q20 User Manual

Routings

To specific ADAT tracks

To route the Q20Õs digital outputs to specific ADAT tracks depends on which of the 8
channels of the buss you use. If you want to record in stereo onto tracks 1 and 2 of
ADAT (or 9 and 10 on ADAT #2 in a chain), route the Q20Õs Left output to channel 1
and its Right output to channel 2. Likewise, if you were recording onto tracks 5 and 6,
then it would be channels 5 and 6 that you would use.
To route the Q20Õs Left and Right outputs to the digital buss:
Press [GLOBAL].
The [GLOBAL] LED will light.
Press [PAGE >] six times to advance to Global Page 6.
The display will read:
DIG CH IN: L= 1 ,R=2
Press the [PAGE >] button two more times to advance the cursor to the third
field in the display.
DIG CH IN: L=1,R=2
Use the [VALUE/ENTER] knob to select an output on the digital buss for the
Left channel to be routed to.
You can select any of the 8 channels, except for the channel the Right output is
assigned to (you cannot route both the Left and Right outputs to the same
channel of the digital buss).
Press the [PAGE >] button to advance the cursor to the next field.
DIG CH IN: L=1,R=2
Use the [VALUE/ENTER] knob to select an output on the digital buss for the
Right channel to be routed to.
You can select any of the 8 channels, except for the channel the Left output is
assigned to.
Record-enable those same track numbers (in this case, 1 and 2) on the connected
ADAT.
You will be able to monitor the Q20Õs output on those tracks of the connected
ADAT.
Q20 Reference Manual
Digital Connections - Chapter 7
OUT: L=1,R=2
OUT: L= 1 ,R=2
OUT: L=1,R= 2
111