Touch Screen Surface; Autoflex Eb - Mitsubishi Electric E1041 Installation Manual

Chemical Resistance
Acetic acid (<50%)
Ariel powder in solution
1
Bleach
Castor oil
Caustic soda (<40%)
Cutting oil
Cyclohexanol
Diacetone alcohol
1
Extremely faint glossing of the texture was noted.
Autotex withstands DIN 42 115 Part 2 exposure of up to 1 hour duration to glacial
acetic acid without visible change.
Autotex is not resistant to high pressure steam at over 100 °C or the following
chemicals:
Concentrated mineral acids
Concentrated caustic solution
Outdoor Use
In common with all polyester based films Autotex F157/F207 is not suitable for use
in conditions of long term exposure to direct sunlight.

4.2.2 Touch Screen Surface

The touch screen surface on the panel withstands exposure to the following solvents
without visible change:
Acetone
Isopropanol
Toluene

4.2.3 Autoflex EB

It is recommended to use the Autoflex EB touch display protection film, that can be
ordered from the manufacturer.
Solvent Resistance
Autoflex EB withstands exposure to the same chemicals as Autotex F157 or F207
according to section
Outdoor Use
In common with all polyester based films Autoflex EB is not suitable for use in
conditions of long term exposure to direct sunlight.
16
1
Gumption
Hydrochloric acid (<36%)
1
Linseed oil
Methanol
Nitric acid (<10%)
1
Paraffin oil
Persil powder in solution
Petroleum spirit
Solvents
Autotex F157/F207.
1
SBP 60/95
Sulfuric acid (<10%)
Tomato ketchup
Trichloroacetic acid (<50%)
White Spirit
1
Windex
1 Wisk
-
1
Benzyl alcohol
Methylene chloride
Time
10 minutes
10 minutes
5 hours
Mitsubishi Electric, MA00818C