Table of Contents
Advertisement
26
en | Recovering the unit
5
Recovering the unit
Following procedure describes how to restore the factory default image.
To restore the unit to factory default image
1. Start the unit and press F7 during the BIOS power-on-self-test.
The Recovery menu is displayed.
Notice!
Make sure that a VGA monitor, a keyboard and a mouse are connected to the unit.
2. Select one of the following:
–
–
Note:
Windows performs the setup. The screen displays the percentage of the process.
Notice!
Do not turn off the unit during the process. This will damage the Recovery media.
3. The unit starts from the Recovery media. If the setup is successfull. press Yes to restart
the system.
4. Windows performs the initial setup of the operating system. The unit restarts after
Windows has completed the setup.
5. After the restart of the unit, the factory default settings are installed and the Windows
logon screen is displayed.
The factory default settings are:
–
–
–
–
2013.09 | V2 | DOC
Initial to factory image (all data will be deleted)
(restores to factory default image and deletes all data on the HDDs)
or
Restore to Factory image (all data will not be deleted)
(restores to factory default image; data on the HDDs will not be deleted)
IP address: 192.168.0.200
Subnet mask: 255.255.255.0
User: BVRAdmin
Password: WSS4Bosch
Installation Manual
Available from A1 Security Cameras
www.a1securitycameras.com email: sales@a1securitycameras.com
DIVAR IP 3000
Bosch Sicherheitssysteme GmbH
Advertisement
Table of Contents
