Camera Protocol; Switching Protocols - Idis DC-D3233FRX-N Operation Manual

Part 1 - Remote Setup
Configure basic network camera settings and all other
system settings.
Screen images may vary depending on the model.

Camera Protocol

Camera supports DirectIP™ and IDIS protocols.
• DirectIP™ protocol:
- Using with a DirectIP™ NVR enables camera use
without the need to configure network settings.
- The DirectIP™ NVR also allows you to control all
camera settings directly from the NVR, without the
need for a computer.
• For more information on configuring camera
settings from a DirectIP™ NVR, refer to the NVR's
operation manual.
• Line Cross, Loitering, and Object Detection
events are not set and operated in the NVR, and Trip
Zone > object measurement function can not be
set in the NVR.
• IDIS protocol:
- Control the camera over the network from software
installed on a computer or a separate NVR.
- Ideal for using the camera over the network from a
remote location.

Switching Protocols

1
Launch the IDIS Discovery program and from the list,
select a camera whose protocol you wish to change.
2
Click on the Setup
Protocol Setup.
• Alternatively, you can right-click on the mouse and
select Protocol Setup.
3
From the Protocol Setup screen, select the desired
protocol and then click OK.
4
This will activate the selected protocol. You can
check each camera's protocol on the IDIS Discovery
program.
This operation manual was written based on the IDIS
protocol use.
icon and then select Setup →
7