Table of Contents
Advertisement
Quick Links
HPP27VMF
Hydraulic Powerpack
From serial
number 12645
Revised
03.04.2019
Prior to Operation
We thank you for choosing a
HYCON powerpack.
Please note that the powerpack
is delivered without hydraulic
oil, and therefore it must be
filled up with hydraulic oil prior
to operation.
To ensure smooth operation
and long-lasting performance of
your new powerpack, we
recommend that you study this
operating manual carefully and
pay special attention to the
Safety and Service
Precautions
We hope you will be satisfied
with your new HYCON power-
pack.
Best regards
HYCON A/S
HYCON A/S
Juelstrupparken 11
DK-9530 Støvring
Denmark
Tel: +45 9647 5200
Fax: +45 9647 5201
Mail
hycon@hycon.dk
www.hycon.dk
Advertisement
Table of Contents
Related Manuals for HYCON HPP27VMF
Summary of Contents for HYCON HPP27VMF
- Page 1 Tel: +45 9647 5200 Fax: +45 9647 5201 Safety and Service Mail hycon@hycon.dk Precautions www.hycon.dk We hope you will be satisfied with your new HYCON power- pack. Best regards HYCON A/S...
-
Page 2: Table Of Contents
Contents Page Safety precautions .................... 2 Filling up hydraulic oil ..................2 Technical data ....................3 Starting instructions ..................4 Setting of flow ....................4 Service, maintenance and hydraulic settings ............5 Oil types ......................6 Warranty conditions ..................6 Spare parts list .................... -
Page 3: Safety Precautions
Safety Precautions 1. Always use protective earplugs. Daily long-lasting operation increases the risk of hearing defects. 2. Always connect hoses before starting. 3. Never add fuel and oil when the engine is running. 4. In case of non-operation or performance of service, always turn off the engine. 5. -
Page 4: Technical Data
EHTMA categories D, E and F, which prescribe a performance of 30, 40 and 60 l.p.m. /8, 10, 16 g.p.m. respectively at 138 bar / 2000 psi. The HYCON powerpack is fully compatible with and sufficient for the common European tools. -
Page 5: Starting Instructions
Starting Instructions Please observe the starting instructions on the front of the powerpack. Start: Check engine oil level Check hydraulic oil level at sight glass Connect hoses and tool Switch fuel tap to “ON” Activate choke ... -
Page 6: Service, Maintenance And Hydraulic Settings
Service, Maintenance and Hydraulic Settings Service/Maintenance Daily Weekly Yearly Engine oil Check 1 x replacement Hydraulic oil Check 1 x replacement Hydraulic oil filter *) 1 x replacement Check hoses (tighten up if needed) Air filter 1 x replacement Fuel filter 1 x replacement *) use only filters with by-pass Hydraulic Settings... -
Page 7: Oil Types
Oil Types The HYCON powerpack uses standard hydraulic oil, i.e. all types of mineral oil and biodegradable oil, which comply with the following values: Recommended viscosity 32-68 cSt Permitted viscosity 15-1000 cSt Viscosity index Min. 100 Temperature area -20° to +70° C -4°F to +160°...
Need help?
Do you have a question about the HPP27VMF and is the answer not in the manual?
Questions and answers