AL-KO 127547 Translation Of The Original Instructions For Use page 64

GB
Fault code
CN012: Cal: no loop
CN015: Cal: outside
CN017: Cal: signal
weak
CN018: Cal: Colli-
sion
CN038: Battery
64
Cause
Fault during the calibration:
■
The appliance cannot
find the boundary cable.
Fault during the calibration:
■
Loop signal too weak
■
No loop signal
■
The boundary cable is
faulty.
Fault during the calibration:
■
The appliance has
bumped into an obstacle.
The rechargeable battery is
flat:
Loop of the boundary cable
is too long, too many islands.
When charging, no contact to
the charging contacts
Obstacles close to the base
station
The appliance has got stuck.
The appliance does not find
the base station.
The rechargeable battery is
depleted.
The charging electronics are
faulty.
Help in case of malfunction
Remedy
■
Check the LEDs on the base sta-
tion.
■
Check the power source of the base
station. Disconnect and reconnect
the power supply.
■
Place the appliance at the pre-
scribed calibrating position; align
precisely at right angles. Appliance
must be able to drive over the
boundary cable.
■
Place the appliance at the pre-
scribed calibrating position; align
precisely at right angles.
■
Check the power source of the base
station. Disconnect and reconnect
the power supply.
■
Check the boundary cable for dam-
age.
Remove the obstacle.
Correct the location of the boundary ca-
ble.
■
Clean the charging contacts.
■
Place the appliance in the base sta-
tion and check that the charging
contacts make contact.
■
Have the charging contacts checked
and replaced by a service centre of
the manufacturer.
Remove the obstacles.
Place the appliance on the free, desig-
nated grass surface.
■
Check the boundary cable for dam-
age.
■
Have the boundary cable repaired
by a service centre of the manufac-
turer.
Have the rechargeable battery replaced
by a service centre of the manufacturer.
Have the charging electronics checked
by a service centre of the manufacturer.
Robolinho 700E/700I