Power Management Setup - Abit NI8 SLI Series User Manual

BIOS Setup

3-6. Power Management Setup

ACPI Suspend Type
X - Resume by USB From S3
Power Button Function
Wake-Up by PME# of PCI
Resume by Ring
Power-On by Alarm
X - Date of Month Alarm
X - Time (hh:mm:ss) Alarm
POWER ON Function
X - KB Power ON Password
X - Hot Key Power ON
Restore on AC Power Loss
↑↓:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5: Previous Values
ACPI Suspend Type:
This item selects the type of Suspend mode.
[S1(PowerOn-Suspend)]: Enables the Power On Suspend function.
[S3(Suspend-To-RAM)]: Enables the Suspend to RAM function.
! Resume by USB From S3:
When set to [Enabled], this item allows you to use a USB device to wake up a system that is in the S3
(STR - Suspend To RAM) state. This item can be configured only if the item "ACPI Suspend Type" is set
to [S3(STR)].
NOTE: To enable this "Resume by USB From S3" function, the wake-up header of [USB-PWR1],
[USB-PWR2], [USB-PWR3], [USB-PWR4] and [USB-PWR5] must be set to [Enabled] position. Please
refer to the configuration of "Wake-up Header" in section 2-4, chapter 2.
Power Button Function:
This item selects the method of powering off your system:
[Delay 4 Sec.]: Pushing the power button for more than 4 seconds will power off the system. This will
prevent the system from powering off in case you accidentally hit or pushed the power button.
[Instant-Off]: Pressing and then releasing the power button at once will immediately power off the
system.
Wake-Up by PME# of PCI:
When set to [Enabled], access to the onboard LAN or a PCI card such as a modem or LAN card will
cause the system to wake up. The PCI card must support the wake up function.
Phoenix – AwardBIOS CMOS Setup Utility
Power Management Setup
F6: Fail-Safe Defaults
S3(Suspend-to-RAM
Disabled
Instant-Off
Disabled
Disabled
Disabled
0
0 : 0 : 0
BUTTON ONLY
Enter
Ctrl-F1
Power Off
Item Help
F7: Optimized Defaults
User's Manual
3-23