Table of Contents
Advertisement
Scan Board setting
Choose the `Scan Board` as shown in Fig 9-7.
LoadFile: Load programmer file from PC, the file is saved and sent out by the manufacturer.
Save file: Save one new programmer file after adjusting parameter.
Read From HW: Read the programmer parameter which is saved into the scan boards in
cabinets.
Send to HW: Send the programmer parameter which is loaded to all the scan boards in
cabinets.
Save: Save the programmer parameter which is sent to all the scan boards in cabinets. After
saving, you will not need to operate again.
Attention:We have saved all the program into the receiving card before delivery, not need to
save it again. We have saved all the programmer file and control system software into
disk
can ask it form out factory.
Please do not make a new programmer file for RV card by yourself, usually it will caused
mistake when you use it.
Fig 9-7
, please check if you got it in the package of spare parts. Also you
the U
52
Advertisement
Table of Contents
