Interior - Sharp MX-M314N Operation Manual

INTERIOR

(15) Toner cartridges
These contain toner for printing. When the toner runs out
in a cartridge, the cartridge must be replaced.
REPLACING THE TONER CARTRIDGES
(16) Upper right side cover
If a paper misfeed occurs while outputting to the job
separator or the finisher (sold separately), open this
cover to remove the misfed paper.
Paper misfeed in the upper exit area (when a job
separator/finisher (MX-FN23) is installed)
(17) Fusing unit
Heat is applied here to fuse the transferred image onto
the paper.
Caution
The fusing unit is hot. Take care not to burn yourself
when removing a paper misfeed.
(18) Right side cover
Open this cover to remove a misfeed.
(19) Paper reversing section cover
This is used when 2-sided printing is performed. Open
this cover to remove a paper misfeed.
(20) Photoconductive drum
This is a drum with a photoconductor coating. The
images are produced on this photoconductor. (The
photoconductor is green.)
Do not touch or damage the photoconductive drum.
This may cause a defective image.
(21) Handle
Pull this out and grasp it when moving the machine.
(15) (16) (17) (18)
(20) (21) (22) (23)
(22) Right cover of paper drawer
(when a paper drawer is installed)
Open this to remove a paper misfeed in tray 3 or tray 4.
(page 1-51)
(23) Paper tray right side cover
Open this to remove a paper misfeed in tray 1 or tray 2.
(24) Bypass tray
Use this tray to feed paper manually.
When loading a large sheet of paper, be sure to pull out
the bypass tray extension.
(page 8-10)
1-4
BEFORE USING THE MACHINE
(19)
(24)
LOADING PAPER IN THE BYPASS TRAY (page 1-33)
Contents