Table of Contents
Advertisement
Removing/Refitting the
Freezer Drawer Handle
Removing the Handle
1
Loosen the set screws
lower side of the handle with a
wrench and remove the handle.
2
Loosen the mounting fasteners
connect to the
freezer drawer
and handle
1
using a
/
in.
4
Allen wrench,
and remove
the mounting
fasteners.
Refitting the Handle
1
Assemble the mounting fasteners
both ends of the handle using a
wrench.
2
Place the handle on the door by fitting
the handle
footprints over
the mounting
fasteners and
tightening the
set screws
1
with a
/
in.
8
Allen wrench.
WARNING
When removing or refitting handles
Hold the handle securely when removing
y
and refitting.
Do not swing the handle or allow children
y
to play with them, or use them for any
other purpose.
Always follow the above instructions when
y
removing or refitting the handles.
Make sure that there is not a gap between
y
the door and handle after refitting the
handle.
located on the
1
/
in. Allen
8
that
at
1
/
in. Allen
4
Removing/Refitting the Doors
and Drawers. (Disconnect the
mains power before removing
any doors and drawers)
When it is necessary to move the fridge
through a narrow opening, removing the doors
is the recommended procedure.
WARNING
If your entrance door is too narrow for
y
the fridge to pass through, remove the
fridge doors and move the fridge sideways
through the doorway.
Use two or more people to remove and
y
install the fridge doors. Failure to do so can
result in back or other injury.
Disconnect the electrical supply to the
y
fridge before installing. Failure to do so
could result in serious injury or death.
Do not put hands, feet or other objects
y
into the air vents or bottom of the fridge.
You may be injured or receive an electrical
shock.
Be careful when handling the hinge and
y
stopper, to avoid injury.
Remove food and bins before detaching the
y
doors and drawers.
INSTALLATION
13
Advertisement
Table of Contents
