Table of Contents
Advertisement
Removing/Assembling the
Freezer Drawer Handle
(On Freezer Drawer Models)
Removing the Handle
1
Loosen the set screws
lower side of the handle with a
Allen wrench and remove the handle.
2
Loosen the mounting fasteners
connect to the
freezer drawer
and handle
1
using a
/
in.
4
(6.35 mm)
Allen wrench,
and remove
the mounting
fasteners.
Assembling the Handle
1
Assemble the mounting fasteners
both ends of the handle using a
(6.35 mm) Allen wrench.
2
Place the handle on the door by fitting
the handle
footprints over
the mounting
fasteners and
tightening the
set screws
with a 3/32 in.
(2.5 mm)
Allen wrench.
CAUTION
When assembling or disassembling the
handles:
.
Grasp the handle tightly to avoid dropping it.
.
Do not swing the handle into nearby people
or animals.
.
Make sure that the bracket hole of the
handle fits properly into the stopper bolt of
the door. Assemble the set screws to fix
the handle into place.
.
Make sure that there is not a gap between
the door and handle after assembling the
handle.
located on the
3
/
in. (2.5 mm)
32
that
at
1
/
in.
4
Removing/Assembling the
Doors and Drawers
When it is necessary to move the refrigerator
through a narrow opening, removing the doors
is the recommended procedure.
CAUTION
.
If your entrance door is too narrow for the
refrigerator to pass through, remove the
refrigerator doors and move the refrigerator
sideways through the doorway.
.
Use two or more people to remove and
install the refrigerator doors. Failure to do
so can result in back or other injury.
.
Disconnect the electrical supply to the
refrigerator before installation. Failure to do
so could result in serious injury or death.
.
Do not put hands, feet or other objects into
the air vents or bottom of the refrigerator.
You may be injured or receive an electrical
shock.
.
Be careful when handling the hinge and
stopper. You may be injured.
.
Remove food and bins before detaching the
doors and drawers.
INSTALLATION
14
Hide quick links:
Advertisement
Table of Contents
