How To Use; Before Use - LG GF-SD730SL Owner's Manual

HOW TO USE

Before use

Clean the fridge.
Clean your fridge thoroughly and wipe off all dust that accumulated during shipping.
Connect the power supply.
Check if the power supply is connected before use.
Read the "Turning On The Power" section. (Your plug type might be different from
the picture.)
Turn off the icemaker if the fridge is not yet connected to the
water supply.
Turn off the automatic icemaker and then plug the power plug of the fridge into the
grounded electric outlet.
* This is applicable only to certain models.
Wait for the fridge to cool.
Allow your fridge to run for at least three to four hours before putting food in it.
Check the flow of cold air in the freezer compartment to ensure proper cooling.
The fridge makes a loud noise after initial operation.
This is normal. The general noise levels will decrease as the temperature lowers.
Open fridge doors and freezer drawers to ventilate the interior.
The inside of the fridge may smell like plastic at first. Remove any adhesive tape
from inside the fridge and open the fridge doors and the freezer drawers for one to
two hours before turning on.
CAUTION
Do not scratch the fridge with a sharp object or use a detergent that
y
contains alcohol, a flammable liquid or an abrasive when removing any tape
or adhesive from the fridge,.
Do not peel off the model or serial number label or the technical information
y
on the rear surface of the fridge.
NOTE
Remove adhesive residue by wiping it off with your thumb or dish detergent.
CAUTION
Running the automatic icemaker before connecting it to the water
supply may cause the fridge to malfunction.
CAUTION
Putting food in the fridge before it has cooled could cause the food to
spoil, or a bad odor could linger inside the fridge.
HOW TO USE 23