Removing/Assembling The Freezer Drawer Handle; Removing/Assembling The Doors And Drawers - LG LFNS22530 Series Owner's Manual

13 INSTALLATION
Removing/Assembling the
Freezer Drawer Handle
Removing the Handle
1
Loosen the set screws
lower side of the handle with a 3/32 in. (2.5mm)
Allen wrench and remove the handle.
2
Loosen the mounting fasteners
connect to the
freezer drawer
and handle
1
using a / in.
4
(6.35 mm)
Allen wrench,
and remove
the mounting
fasteners.
Assembling the Handle
1
Assemble the mounting fasteners
both ends of the handle using a
(6.35 mm) wrench.
2
handle
footprints over
the mounting
fasteners and
tightening the
set screws
with a 3/32 in.
(2.5 mm)
Allen wrench.
WARNING
When assembling or disassembling the
handle:
y Grasp the handle tightly to avoid drop-
ping it.
y Do not swing the handle into nearby
people or animals.
y Make sure that the bracket hole of the
bolt of the door. Assemble the set
y Make sure that there is not a gap
between the door and handle after
assembling the handle.
Removing/Assembling the
Doors and Drawers
When it is necessary to move the refrigerator
through a narrow opening, removing the doors
located on the is the recommended procedure.
that
at
1
/ in. Allen
4
WARNING
y If your entrance door is too narrow
for the refrigerator to pass through,
remove the refrigerator doors and move
the refrigerator side ways through the
doorway.
y Use two or more people to remove and
install the refrigerator doors. Failure to
do so can result in back or other injury.
y Disconnect the electrical supply to the
refrigerator before installation. Failure
to do so could result in serious injury or
death.
y Do not put hands, feet or other objects
into the air vents or bottom of the
refrigerator. You may be injured or
receive an electrical shock.
y Be careful when handling the hinge and
stopper. You may be injured.
y Remove food and bins before detaching
the doors and drawers.