Step 4. Installing The Conduit - Samsung FE-N500WX Installation Manual

stEP 4. instAllinG thE ConDuit

Remove the conduit connection plate from the rear of the drawer body and rotate it as shown below.
The conduit hole (1
1. Prepare the conduit cord shown in Figure 1.
2. Install the conduit cord as shown in Figure 2.
For conduit installations, insert the strain relief (not included) into the conduit hole (1
the conduit cord through the body of the strain relief and fasten the ring. Reinstall the bracket.
Installing a 3-wire conduit
• Aluminum building wire may be used but it must be rated for the correct amperage and voltage to
make the connection. Connect wires according to Step 4 depending on the number of wires.
• Wire used, location and enclosure of splices, etc., must conform to good wiring practices and local
codes.
1. Loosen the 3 lower terminal screws from the terminal
block.
2. Insert the center bare wire (white/neutral) tip through
the bottom center terminal block opening. On certain
models, the wire will need to be inserted through the
ground strap opening and then into the bottom center
block opening.
3. Insert the two side bare wire tips into the lower left
and the lower right terminal block openings.
4. Tighten the screws until the wire is firmly secured (35
to 50 inch-lbs.). Do not over-tighten the screws since
it could damage the wires.
5. Go to step 5 on page 10 and proceed with the
installation.
Installation-USA DG68-00108E-01_EN.indd 9
/ ") must be used.
1
8
Figure 1
1" / " 1"
3
8
3 / "
1
2
3 wire 4 wire
Knockout surface
Conduit connection plate
"
1 /
1
8
"
1 / 1 /
3 1
8
/ "
3
8
3 / "
1
2
"
1 /
3
8
"
8
Figure 2
Ring
Body
Strain relief
/ "). Then thread
1
8
Ground
Neutral
strap
terminal
White
Black Red
White
Black
Red
Wire tips
Connecting the power _9
2011-03-18 4:06:28