Table of Contents
Advertisement
Time format: Day/Month/Year/Hours/Minutes/Seconds, after setting, press set in the upper left corner of
the screen to confirm and save.
19. Password settings
Password for system settings and settings.
Press the "Settings" icon in the main menu and select the "Password Protection" menu.
3 protection modes are possible:
(1) Unprotected: No password required for all settings.
(2) Partial protection: You need to enter a password to set up your system. To access you do not need to
enter a password on the settings menu.
(3) Full protection: A password is required to enter system settings and settings.
Note:
(1) After selecting protection mode you can set 4 local password default password is: 0000)
(2) To confirm the password entry" # "icon, press "* " to cancel the input.
20. Password protection of the list of entry stations
If you enable any protection mode you must edit the the default password is "0" and you can set it as a
password for system settings.
Instructions:
Press the settings icon in the main menu, select "Device Configuration", then List of Input Stations " and
select the desired input station, go to "Edit ", enter the default password "0" and confirm with the " # "
icon. Select "Password settings" and set a new password with 1 to 8
numbers.
Note: If you are entering a password for the list of entry stations, you must enter a number that does not
have the first digit 0.
Reset Password:
(1) Reset your system password: If you forget your password to access system settings, follow these steps,
restart the monitor and go to settings.
After restarting the monitor a password is not required for the first entry into the settings. Go to the
Password Protection menu and set your password as needed.
(2) Reset the password for the entry station list: If you forget the password for the list of input stations
at one entry station, press and hold the reset button on the input station to reset it. Successful
confirmation of password reset is confirmed twice by beep.
21. Setting the room address
Press the settings icon in the main menu, go to the device configuration option, select the room address,
and set the address you need.
Note: (1) the room address has 8 digits, but if you are using internal calls, it must not be first digit set to 0
(2) For monitors installed in the same family, the room address must be set to the same Value. If you ring
the entry station, all monitors will ring at the same time and you can answer any one.
22. Set the monitor name
Each monitor can have its own name. Monitor names are selected only when you make an internal call.
Press the settings icon in the main menu, go to device configuration, and select the device name to change
the name of the monitor.
Advertisement
Table of Contents
