Table of Contents
Advertisement
Reset Password:
(1) Reset your system password: If you forget your password to access system settings, follow these steps,
restart the monitor, and go to settings.
After restarting the monitor, a password is not required for the first entry into the settings. Go to the
Password Protection menu and set your password as needed.
(2) Reset the password for the entry station list: If you forget the password for the list of input stations
at one entry station, press and hold the reset button on the input station to reset it. Successful
confirmation of password reset is confirmed twice by beep.
21. Setting the room address.
Press the settings icon in the main menu, go to the device configuration option, select the room address,
and set the address you need.
Note: (1) the room address has 8 digits, but if you are using internal calls, it must not be
first digit set to 0
(2) For monitors installed in the same family, the room address must be set to the same
Value. If you ring the entry station, all monitors will ring at the same time, and you can answer any one.
22.Set the monitor name.
Each monitor can have its own name. Monitor names are selected only when you make an internal call.
Press the settings icon in the main menu, go to device configuration, and select the device name to change
the name of the monitor.
23. Set the name of the entry station.
Press the settings icon in the main menu, select "device configuration ",then
"List of entry stations "and select the desired entry station, go to the "Edit" option,
enter the correct password (the default password is "0") and confirm with the "#" icon. Select the device
name menu to change the name of the entry station.
24. Reset some parameters in the system.
Press the settings icon in the main menu to select the reset menu and select the parameters you want to
reset.
25. Setting up the entrance station.
Press the "settings" icon in the main menu, select "device configuration ",then "List of input stations ", and
select the desired input station , go to "Edit ", enter
correct password (default password is "0") and confirm with the "#" icon. Here you can set all
theparameters of the
station.
entrance
26. Device number.
The device number is 8 digits, you can set any one. If there is more than 1 entry station in the system,
you must not use the same device number for 2 input stations.
27. Button address.
By default, the address is button 1, and the default address of the monitor room is also 1.
After installation, you can call the internal monitor. If you have changed the "room address" on the
monitor,
you must also set a call target for the input station buttons.
Settings: Select the button 1 address menu in your input station settings and set the room address of the
monitor you want to call. After setting up, you can press the button at the entrance station to call monitors
with the room address set.
Advertisement
Table of Contents
