Operation - Dimplex PF3033 Service Manual

Operation

WARNING: This electric firebox must be properly in-
stalled before it is used.
This firebox operates with Comfort$aver
automatically adjusts the fan speed and heater wattage to
safely and precisely match the requirements of the room
based on the thermostat setting. The heater operates such
that once the room reaches the set point, the fan and heater
will continuously run at a low level, to maintain the desired
room temperature. If the temperature in the room rises signifi-
cantly, i.e. sun coming through a window or a central furnace
turns on, the heater and fan will turn off and periodically turn
back on to circulate the air around the unit, until the room
temperature drops and requires the heater to be constantly
on again.
!
NOTE: The unit is designed so that the fan will run con-
tinuously while the heater is on.
!
NOTE: The element retains heat after shutdown, there
is a built in cool down period of 1 minute before the fan shuts
off completely.
gWave Controls
TM
The fireplace can be operated by a simple "wave" in-front of
the unit. By waving your hand vertically approximately 4 in.
(102 mm) in-front of the gWave
hand corner of the unit, the unit and different control functions
can be activated. This is also indicated by the LED light turning
green.
There is a Gesture On/Off button located below the LED
pilot light which can be used to turn this feature On or Off.
Figure 1
gWave
Controls
⑥
⑦
③
technology, which
TM
sensor in the upper right
TM
TM
LED Pilot Light
⑩
⑪
It is recommended that a straightened paperclip be used to
press the button through the small hole. When the gWave
controls are turned off, the green light will flash 4 times
before turning off and it will remain solid green when the
gWave controls are active.
TM
!
NOTE: The unit is programmed to have a built in demon-
stration mode to exhibit all of the functions of the unit in a 95
second period of time. This can be activated by holding your
hand in front of the gWave
unit has gone through the demonstration mode once it will
return to the previous operation.
Remote Operation
The fireplace is supplied with an IR multifunction remote
control.
!
NOTE: To operate correctly, the remote control must
be pointed towards the front of the unit.
Controls
1 . Standby:
→ Activated by pressing the corresponding button on the
remote or "waving" in-front of the gWave
turn the unit On and "Waving" down will turn the unit Off.
• The unit will turn on with the same functions that it was set
to when it was turned Off and the intake temperature will be
indicated on the On Screen Display.
!
NOTE: When any button is pressed the intake tem-
perature will be displayed on the On Screen Display for 5
seconds.
2 . Flame On/Off:
②
④
Gesture On/Off
⑥
⑧
⑩
sensor for 7 seconds. When the
TM
Turns unit On or Off.
Turns the flame effect On or Off.
①
③
⑤
⑦
⑨
TM
. "Waving" up will
TM
3