Dexter Laundry T-350SWD Operators Manual Installation & Operation Instructions page 29
Commercial washer vended c-series control – 50hz, (lower extract)
Hide thumbs
Also See for T-350SWD:
Table of Contents
Advertisement
The figure below shows the sub menu options for Temp Pricing:
Cycles Option:
This option allows the user to set the bath time and spin time for the "Wash" bath. It
also allows the user to set bath time, water temperature and spin time for "Rinse" and
"Final rinse" baths. (Water temperature for the "Wash" bath is chosen by the customer
using the "Hot", "Warm" and "Cold" buttons on the front of the machine). For the
"Final Spin" it also allows the user to set the spin speed (see additional description
below).
It also allows the user to return the values to factory defaults. To reset all values in the
Cycles option to factory default, press "Enter" when the "DEFAULT" prompt is shown.
Press "Enter" again when the "RESET" prompt is shown to confirm the action.
1. "Final Spin" is the spin that occurs after all selected baths & intermediate spins
have been completed. It is a higher spin speed than previously occurring
intermediate spins. The benefit of this higher spin speed is that more water is
extracted from the wash load, which minimizes the drying time needed.
However, in some cases, if the Dexter installation guidelines are not followed
properly, it may be necessary to reduce the spin speed of the "Final Spin".
The "Final Spin" can be adjusted in increments of 10 G for washers with 90 or
100G maximum spin speed and increments of 20 G for washers with a 200G
maximum spin speed. The factory default "Final spin" speeds are the maximum
values.
Model
T-300*
T-350** or T-350 SWD
T-400
T-450 or T-450 SWD
T-600
T-650
T-750 or T-750 SWD
T-900
T-950
T-1200
T-1450
* T-300 Model (Lower Extract) has a maximum final spin speed of 90G.
Programming 90 or 100G will both result in a spin speed of 90G. 60, 70 & 80G
settings will operate as programmed.
** T-350/T-350SWD Models (Lower Extract) have a maximum final spin speed of
180G. Programming 180 or 200G will both result in a spin speed of 180G. 60,
80, 100, 120, 140 & 160G settings will operate as programmed.
8514-302-001 REV B page 29
Adjustable Final Spin
Range
60G to 90G
60G to 180G
60G to 100G
60G to 200G
60G to 100G
60G to 200G
60G to 200G
60G to 100G
60G to 200G
60G to 100G
60G to 200G
Advertisement
Table of Contents
