Water - Air Or Water Cooled - Scotsman Prodigy Plus D Series Installation And User Manual

N0422, F0522, N0622, F0822, N0922, F1222, N1322, F1522
D Series Air, Water or Remote User Manual

Water - Air or Water Cooled

The water supply for ice making must be cold, potable
water. There is a single 3 8" male flare potable water
connection on the back panel. Water cooled models
also have a 3/8" FPT inlet connection for the water
cooled condenser. Chilled water can also be used for
this connection.
Backflow
The design of the float valve and reservoir prevents
potable water backflow by means of a 1" air gap
between the reservoir's maximum water level and the
float valve water inlet orifice.
Drain
There is one ¾" FPT condensate drain fitting at the
back of the cabinet. Water cooled models also have a
½" FPT discharge drain connection on the back panel.
Attach Tubing
Connect the potable water supply to the potable water
fitting, 3/8" OD copper tubing or the equivalent is
recommended.
Water filtration is recommended. If there is an existing
filter, change the cartridge.
Connect the water cooled water supply to the
condenser inlet.
Note: Do NOT filter water to the water cooled
condenser circuit.
Drains - use rigid tubing: Connect the drain tube to the
condensate drain fitting. Vent the drain.
Connect the water cooled condenser drain tube to the
condenser outlet. Do not vent this drain.
Do not Tee ice machine drains into the drain tube
from the ice storage bin or dispenser. Back ups
could contaminate and / or melt the ice in the bin or
dispenser. Be sure to vent the bin drain.
Follow all local and national codes for tubing, traps
and air gaps.
Water Inlet
Connection
Drain
Connection
Condensate
Drain Tube
Building Drain
Air Cooled or Remote Plumbing
Water Inlet
Connection
Drain
Connection
Condensate
Drain Tube
Water Cooled Plumbing
December 2014
Page 7
Condenser Inlet
Connection
Condenser
Drain Tube