Viking MVSOC530 Installation Manual page 8

Installation Instructions for Standard Surface Mount
WARNING
Always take caution lifting heavy products.
2. Use a minimum of 2 people to lift and install oven.
Place the oven adjacent to the cabinet opening,
see Figure 4. Plug the power supply cord into the
electrical outlet.
3. Carefully guide the oven between the mounting
brackets. Avoid pinching the cord between the oven
and the brackets.
4. Slide the oven all the way back until the oven frame
is seated against the cabinet and the mounting
brackets.
DO NOT
lift this unit
using the outer
oven frame
Lift point
on frame
Figure 4
5. Open the oven door and insert the 4 mounting bolts
supplied. Do not completely tighten. See Figure 5.
Figure 5
6. Open the drip tray door and insert the 2 shoulder
bolts supplied. See Figure 6. Do not completely
tighten.
Side Handle (x2)
E8
Note: Slide on shoulder bolt sleeves before mounting
Figure 6
7. Check alignment of oven then tighten the 4
mounting bolts in Figure 5 and the 2 shoulder bolts
in Figure 6 to secure oven.
8. Install Handle. Loosen the two set screws on the
handle, apply lock tite to the set screws. Slide the
handle over the studs on the oven door and tighten
the set screws using the provided allen wrench.
Note: the set screws on the handle should be facing
down during installation. See Figure 7.
Figure 7