Continuous Pilot / Intermittent Pilot (Cpi / Ipi) Selection; Key Lock; Low Battery / Manual Bypass - Napoleon LHD62P Installation And Operating Instructions Manual

8.6

CONTINUOUS PILOT / INTERMITTENT PILOT (CPI / IPI) SELECTION

A. Use the Mode Key to guide you to the CPI mode
icon. Transmitter in the OFF position.
B. Press the UP/DOWN to switch between IPI and
CPI modes. A single BEEP will confi rm reception
of the command.
Note: If the system is equipped with a CPI/IPI
toggle switch, set the CPI/IPI to CPI position to
enable remote CPI operation. If the switch is set
to IPI then it will only work in IPI regardless of
what is set on the remote control handset.
8.7

KEY LOCK

This function will lock the keys to avoid unsupervised operation.
A. Press the MODE and UP keys at the same time.
B. To de-activate this function, press the MODE and UP keys at the same time.
8.8

LOW BATTERY / MANUAL BYPASS

The life span of the remote batteries depends on various factors: quality of the
batteries, the number of ignitions, the number of changes to the room thermostat set
point, etc.
When the transmitter batteries are low, a Battery Icon will appear on the LCD
display before all battery power is lost. When the batteries are replaced this icon will
disappear.
Not applicable when plugged into 110V.
When the batteries are low, no "beep" will be emitted from the receiver when it
receives an ON/OFF command. This in an alert for the receiver that there's low battery. When the batteries are
replaced the "beep" will be emitted from the receiver when the ON/OFF key is pressed.
If the batteries in the battery holder or transmitter are low, the appliance can be turned on manually by sliding
the three position slider switch on the battery holder to the "ON" position. This will bypass the remote control
feature and the appliance main burner will come on. Likewise, if you want to manually turn the appliance off,
slide the switch to the 'OFF' position.
76
°F
CPI
IPI
35.22
35.10A
35.23
41
76
°F
EN
76
°F
76
°F
W415-1334 / 06.10.14