Table of Contents
Advertisement
1
2
1. Coolant reservoir cap
2. Coolant reservoir hose
7. Place a container under the coolant res-
ervoir.
8
8. Disconnect the coolant reservoir hose
and drain the reservoir.
9. After draining both the radiator and the
reservoir, thoroughly flush the cooling
system with clean tap water.
10. Install the coolant drain bolt with a new
gasket, and then tighten to the specified
torque.
Tightening torque:
Coolant drain bolt:
8 N·m (0.8 kgf·m, 5.9 lb·ft)
11. Connect the coolant reservoir hose.
12. Pour the specified amount of fresh cool-
ant into the radiator, then install the radi-
ator cap.
13. Pour the specified amount of fresh cool-
ant into the reservoir, then install the res-
ervoir cap.
14. Remove the right panel and right rear
panel. (See page 8-11.)
15. Loosen the water pump air bleed bolt to
allow air to escape from the system.
8-27
Advertisement
Table of Contents
Troubleshooting
