Table of Contents
Advertisement
OPERATION
2. Operate accessory tool as normal (Figure 7).
NOTE: Before cleaning upholstery, always check
cleaning instructions sewn in furniture by
manufacturer.
3. After cleaning, relieve water pressure from tool
before disconnecting hose. Squeeze trigger for
five seconds after turning switches off.
DRAINING TANKS
DRAINING RECOVERY TANK
1. Turn machine off.
2. Insert supplied 45° elbow in drain valve. Place a
bucket below it and slowly pull up on the handle
(Figure 8).
3. Rinse tank with clean water at the end of the day.
6
Fig. 7
Fig. 8
Fig. 8
DRAINING SOLUTION TANK
1. Remove empty-out nozzle from its storage
bracket (Figure 9) and attach to end of solution
hose.
2. Place empty-out nozzle over a bucket and turn on
pump until all the solution has been pumped from
solution tank.
3. Replace empty-out nozzle to its storage location.
FREEZE PROTECTION
1. After draining solution tank as described in steps
one and two in the previous section (DRAINING
SOLUTION TANK), place empty-out nozzle in
end of vacuum hose and seal with hand
(Figure 10).
2. Turn on vacuum and pump for 15 seconds. This
will fill the pump and hoses with air and prevent
freezing.
3. Replace empty-out nozzle to its storage place.
Fig. 9
Fig. 10
36406E3 (03-02)
Advertisement
Table of Contents
