Table of Contents
Advertisement
OPERATION
2. Operate accessory tool as normal (Figure 7).
NOTE: Before cleaning upholstery, always check
cleaning instructions sewn in furniture by
manufacturer.
3. After cleaning, relieve water pressure from tool
before disconnecting hose. Squeeze trigger for
five seconds after turning switches off.
DRAINING TANKS
DRAINING RECOVERY TANK
1. Turn machine off.
2. Place a bucket below the drain valve and slowly
pull up on the handle (Figure 8).
3. Rinse tank with clean water at the end of the day.
6
Fig. 7
Fig. 8
Fig. 8
DRAINING SOLUTION TANK
1. Use a spare male quick disconnect and place it in
the end of the solution hose (Figure 9).
Fig. 9
2. Hold the end of the hose over a bucket and turn
on pump until all the solution has been pumped
from solution tank (Figure 9).
FREEZE PROTECTION
1. After draining solution tank as described in steps
one and two in the previous section (DRAINING
SOLUTION TANK), place the spare male quick
disconnect that is in the end of the solution hose
in the end of vacuum hose and seal with hand
(Figure 10).
2. Turn on vacuum and pump for 15 seconds. This
will fill the pump and hoses with air and prevent
freezing.
Fig. 10
61421012AK (06-17)
Advertisement
Table of Contents
